![]() Manufacturer: Eaton Sure Power battery isolators eliminate multi-battery drain when 2 or more battery banks are in a charging system. Universally suited for mounting on tow vehicles. Start assist feature parallels batteries for added power during start. Howard Kelsey from Tulsa, OK United StatesĪrrived as promised, exact replacement for existing switch.Īnonymous Person from San Ramon, CA United StatesĮxact form factor as 1314-200 that it replaced on my RV that had solar panels installed. Protection circuitry absorbs coil generated voltage spikes. Others with on-line stores can't tell you if they really have your item in inventory or are going to have to backorder it. ASE confirmed for me on the phone that they really did have it in stock. I needed this unit to replace one in my RV that had failed. Great service - fast, friendly, responsiveĮdward Hershberg from Portland, OR United States William Efimoff from DERIDDER, LA United States Thus providing the starter system with maximum battery voltage available.Ġ of 0 people found the following review helpful: When the engine is started, the start signal causes the controller to check if the auxiliary battery is within about 0.85V of the main battery if so, the relay contact is closed. This will cause the relay to be opened shortly after the engine is stopped, attempting to preserve 100% of the starting battery capacity for engine cranking. The disconnect voltage is set to a nominal 12.8V, which is near the full charge resting voltage of the batteries. This will cause the relay to close and the charging system can charge both banks of batteries. The connect threshold is set to a nominal voltage of 13.2V, which would only be reached when the charging system is operating. If the main battery (for the 1314-200) or either batteries (for the 1315-200) are below the disconnect threshold the unit will open the relay. If the main battery (for the 1314-200) or either battery bank (for the 1315-200) is above the connect threshold, the relay connects the two banks together. The units monitor both the main and auxiliary battery banks. The 1314-200 (unidirectional) and 1315-200 (bidirectional) are 200A battery separator modules with an integrated relay for 12V systems.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |